Endless Solar Hot Water System Dimensions and Power Usage
Endless Solar Collectors

Measurements* 10 tube collector 22 tube collector 30 tube collector
Weight (including standard frame/tubes/manifold) 40kg 82kg 108kg
Height of collector (including manifold) 2000mm 2000mm 2000mm
Width of collector 885mm 1845mm 2485mm
Distance between inlet and outlet ports** 815mm 1775mm 2415mm
Surface Area of collector 1.77m2 3.69m2 4.97m2
Weight of Low Pitched Roof Frame 6.0kg 10.5kg 11.1kg
Weight of A-Frame (for flat roofs) 7.5kg 11.5kg 12.1kg

* All measurements are approximate and may vary
**Inlet and outlet ports are at the top of the collector

Endless Solar Electric Boosted Tanks - Left hand ports including flow & return

TankSize Height of Tank Tank Diameter WeightofTank Hot WaterOutlet ReturnFlow(to Tank) Cold Water Inlet
250L 1606mm 566mm 65kg 1195mm 370mm 168mm
315L 1961mm 580mm 78kg 1495mm 425mm 168mm

Note: Distances given are from the base of the tank

Endless Solar Gas Boosted Tanks - Left hand ports with flow & return ports in center

Tank Size Height of Tank Tank Diameter WeightofTank HotWater Outlet Return Flow**(to Tank) SolarFlow(from Tank) ColdWater Inlet
250L 1606mm 566mm 65kg 1195mm 465mm 365mm 255mm
315L 1961mm 580mm 78kg 1495mm 465mm 365mm 255mm


Note: Distances given are from the base of the tank

Distance that gas booster protrudes from the tank when mounted on the tank using the Mounting Bracket = 215mm

Power Usage

Component Power Usage
Controller 240v / 2W
Solar Pump 240v / 28W
Gas Booster 240v / 36W in standby – 125W when antifreeze mode is on (0o C or below)

½ inch copper pipe is recommended for the solar flow and return lines. If there is low pressure then ¾ inch can be considered. Please check with an Endless Solar distributor if unsure. Instantaneous gas booster supply lines are ¾ inch.